BCS SD03 speed dome 66 Manual de instalación descargar pdf (Pagina 21)

3 Protocol, Baud Rate, Address setup

Before you operate, you need to set protocol, baud rate and address.

Otherwise you can not control the product!

3.1 Protocol and Baud Rate Setup

Please configure the following settings before begin controlling dome:

z Protocol

z Baud rate

z Address

Note: Please reboot the speed dome to get all the setups activated!

Open the lower dome, the interface is shown as below. See Figure 2-1.

Figure 3-1

Please refer to the protocol sheets for detailed information.

Protocol Baud rate Parity

1 2 3 4 5 6 7 8

1 2 3 4 Communication Protocol

OFF OFF OFF OFF

DH-SD（Compatible with China

industrial standard protocol）

ON OFF OFF OFF PELCO-D

OFF ON OFF OFF PELCO-P

X X X X Reserved

Please refer to the baud rate sheet for detailed information.

5 6 Baud Rate

1 2 ... 16 17 18 19 20 21 22 23 24 25

Sin comentarios

BCS SD03 speed dome 66 Manual de instalación Pagina 21