BCS SD03 speed dome 66 Manual de instalación descargar pdf (Pagina 19)

Teflon tape

M4 Screw

Silica gel

Figure 2-21

Please loosen the M4 bolt at the splicing sleeve of pole bottom (just a little will be

O.K), then turn the screw thread of the upper cover splicing sleeve in. Now pull the

power cable through the upper cover and then turn the upper cover to the pole

splicing sleeve firmly. Fix the M4 bolt. Loosen the captive screw in the panel. See

Figure 2-22.

Please note, if the speed dome is installed in outdoor environment, please enlace

enough Teflon tape at the screw thread of pole and then turn the pole to the

connection flange firmly.

Please use silica gel to secure waterproof between pole connection splicing

(coupling) sleeve and the connection port.

Please refer to Figure 2-22 to loosen captive screw and then open panel.

M4 Screw

Teflon tape

Figure 2-22

Cable connection: Please refer to Figure 2-5.

Bottom cover connection: Please refer to Figure 2-8.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Sin comentarios

BCS SD03 speed dome 66 Manual de instalación Pagina 19